The value control box (VCB) is situated at the right side of
the status bar. The skethup users can access various information regarding dimension
at the time of drawing anything. The sketchup users can also put in values into
the VCB to maneuver the entities which are already selected. (Generate elements
concerning a particular dimension.
VCB contains the following characteristics:-
The users can provide a value in the VCB prior to or after
the completion of an operation provided that the value is penetrated before
commencing of a new operation.
The users should select enter or return key for the
acceptance of a typed value.
The value of the geometry can be modified as many times
according to the preference of the users before commencing a new operation.
If the users go out of any tool, the VCB can’t be utilized
again to put in value for that tool.
Sketchup will demonstrate a tilde (~) before the number to
point out that a number is not accurate (not inside precision settings as
provided in the unit panel of the model into dialogue box.
The users don’t have to connect in the VCB prior to typing.
The VCB constantly waits for input from the keyboard.
The users will be able to put values in the VCB through an
alternate measuring system than the default system. The sketchup will transfer
the value to the default system. As for instance, the users can provide 3’6”
even they are applying metric system as default. Units are arranged inside the
units panel of the model info dialogue box.
~~~~~~~~~~~~~~~~~~~~~~
Published By
Arka Roy
www.sketchup4architect.com
~~~~~~~~~~~~~~~~~~~~~~
No comments:
Post a Comment